If you have successfully connected to the device then try different controls to check if everything is okay.įor more remote codes, click here.If the light blinks 4 times and then goes off it means you have written an invalid code and so you have to follow all the steps from the beginning. If it stays illuminated then you have entered the correct code. Important: You may have to press OFF/ON up to 200 times. Press and release OFF/ON until your device turns off. The INDICATOR LIGHT will blink once then remain lit. When you have completed entering the 5 digits see if the power light is still illuminated. Press and release the device button for the device you are programming (TV, VCR/DVD or DBS/CABLE).Now hold down the Power Button on the remote and then press the Channel up them until the device in this case your tv Turns Off. After entering the first digit you will notice the power light will go off. Its a code in manual which forces the remote into the search mode.Now, while holding the device key enter the device code that you want to pair, you can find the code mentioned below in the table.Now press and hold the device button you want to connect to such as the TV button, VCR button, or the SAT button, you will notice after pressing and holding a button the power button will turn on and will remain on.Turn on the device and install the correct batteries on your remote.Follow these steps to connect your remote to any device:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |